Advertisement
Determine the exact mounting location of the wall mount prior to the installation, considering the swing of the articulating arm.
The AWM125-120 mount must be secured to the CENTER of the wall stud capable of at least (4) times the weight of the display and
The height of the AWM125-120 should be mounted at the same horizontal center line as the desired display center line (viewing center line).
1:Position the AWM125-120 mount to the desired position. Mark and Pre drill the top and bottom holes with a 3/16" (5mm) hole . SEE FIG 2
2: Insert the lag bolt and washer (item 11 and 12) into the top hole and secure to the AWM125-120 mount.
3: Next insert the second lag bolt and washer
4:Fully extend the arm and swing the mount from left to right . Check that the mount is level in both positions. If necessary loosen the bottom bolt and set to a level
position and re tighten the bolt.
5:Pre drill and Install the center lag bolt and tighten. SEE Fig 2
Fig 2
WOOD STUDS
(std construction 2 x 4
studs and 1/2" wallboard)
lag bolts
1: Lay the display face down on a padded surface.
2: Using the hardware supplied ( see page 3) attach the display bracket to the display. SEE FIG 3
3: Check the depth of the mounting holes to assure you are using the proper length screws supplied .
4: Make note to attach the top of the display bracket to the top of the display.
5: Spacers
and longer screws
supplied (1,3,4,7), may be necessary for use, to avoid obstructions on the back surface of the display.
6: Make sure to tighten all fasteners before mounting on the AWM125-120 arm. Care should be taken to not over tighten bolts into the display.
NOTE: Do not over tighten the bracket mounting screws as damage to the display internal mounting threads could occur.
Fig 3
Panel display bottom edge
1. FASTEN MOUNT TO THE WALL
(item 11 and 12)
into the slotted bottom hole. Position with a level tighten the bottom bolt.
Adjustment for level
2. ATTACH THE DISPLAY BRACKET TO THE DISPLAY
SEE FIG 3
DISPLAY CENTER LINE
C L
4°
Mounting hardware 1,2,3,4,5,6,7,8,9
Linear multi washer (15)
5
AWM125-120
mount.
VIEWING
HORIZONTAL
CENTER LINE
FLOOR LINE
Display bracket
Optional plastic spacers ( 3 )
Advertisement
