Haier QFT15 Series Owner's Manual & Installation Instructions page 20

STACKING THE WASHER AND DRYER (if desired)
If you are planning to stack the washer and dryer, order Stacking Kit number GFA24KITL to be used for this dryer.
Kit sold separately.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
local electrical inspector's use.
IMPORTANT
•
and ordinances.
Note to Installer
• – Be sure to leave these
instructions with the Consumer.
Note to Consumer
•
future reference.
• Service must be performed by a qualified installer.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
• Proper installation is the responsibility of the installer.
HAIER APPLIANCES STACK KIT
Visit our website at haierappliances.com/parts or in
Canada visit haiercanada.ca/parts.
Part Number Accessory
GFA24KITL Complete Stack Kit
REQUIREMENTS FOR ALCOVE OR
CLOSET INSTALLATION
WARNING - Explosion Hazard
Keep flammable materials and vapors, such as gasoline,
away from dryer.
Place dryer at least 18" (46 cm) above the floor for a
garage installation.
Failure to do so can result in death, explosion, or fire.
• Minimum clearance between dryer cabinet and
adjacent walls or other surfaces is:
0" either side
1" front and rear
1" top
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches of open
area. If the closet contains both a washer and a dryer,
doors must contain a minimum of 120 square inches
of open area.
20
INSTALLATION INSTRUCTIONS
– Save these instructions for
– Observe all governing codes
– Keep these instructions for
MINIMUM CLEARANCE OTHER THAN
ALCOVE OR CLOSET INSTALLATION
Minimum clearance to combustible surfaces and
for air opening are: 0" both sides, 1" rear and 1" top.
Consideration must be given to provide adequate
clearance for installation and service.
KIT CONTENTS (GE APPLIANCES KIT
# GFA24KITL)
Screws (2) Long
For dryer
attachment
Bracket-
stack (R)
TOOLS YOU WILL NEED
Phillips
screwdriver
Level
INSTALLATION PREPARATION
Remove the packaging.
Flatten the product carton to use as a pad to lay the
dryer down on its side. Continue using the carton to
protect the finished floor in front of the installation
location.
Bracket-
stack (L)
Screws (6) Short
For washer attachment
Gloves
49-3000193