Advertisement
Installation Of Your Power Lift Chair Model: 119 continued
4
Tighten Existing Bolt
Tighten Existing Bolt
5
6
7
Specification Q t y.
Tighten Existing Bolt
4. Rotate the back recline bar to
align with the holes in the back
section as shown. Install two
screws with lock washers into
the holes identified by the arrows.
Tighten the screws securely with
the supplied wrench or a 7/16" box
wrench.
5. Slide the back down between the
brackets until the threaded studs
on the back slip thru the holes in
the brackets as shown.
6. Thread the flange lock nuts,
located in the arm cover bag, onto
the studs and tighten securely
using the supplied wrench or a
7/16" box wrench.
8
Advertisement
