Advertisement
Ensure that the unit is fully charged before storage.
1.3
ELECTRiCAL SAFETY (with respect to mains chargers)
WARninG! It is the user's responsibility to check the following:
You must check the AC adaptor to ensure that it is safe before using. You must inspect the power supply lead, plugs and all
electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of appropriate
safety devices. An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We recommend that
an RCD (Residual Current Device) is used with all electrical products. It is particularly important to use an RCD with portable products
that plug into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You can obtain a Residual
Current Device through your Sealey dealer. You must read and understand instructions concerning electrical safety.
1.3.1
The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
person, using a Portable Appliance Tester (PAT), at least once a year.
1.3.2
The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.3.3
DO ensure that the insulation on all cables and the product itself is safe before connecting to the mains power supply.
1.3.4
DO ensure that cables are always protected against short circuit and overload.
1.3.5
DO regularly inspect power supply, leads, plugs for wear and damage and power connections to ensure that none is loose.
1.3.6
DO check product voltage is the same as power supply to be used.
1.4
COMPRESSOR SAFETY (RS122 OnLY)
Keep children and non essential persons away from the inflation area.
WARninG! This compressor is capable of producing a high pressure (100psi). DO nOT inflate any item beyond its maximum capacity.
DO nOT direct inflation hose connector head at yourself, others or animals.
DO nOT leave the compressor operating unattended. Always monitor the inflation pressure gauge.
DO nOT carry by the hose, or yank the hose from an inflation valve.
DO nOT pull the power cable from the cigarette lighter socket by the power lead.
DO nOT get the compressor wet or use in the rain.
DO nOT use the compressor for a task it was not designed to perform.
DO nOT operate the compressor when you are tired, under the influence of alcohol, drugs or intoxicating medication.
DO nOT operate the compressor if any parts are missing or the generator is damaged as this may cause failure and/or possible
personal injury.
nOTE: The pressure gauge is not a calibrated instrument. We recommend use of an approved dial/pressure gauge for a definitive reading.
2. inTRODUCTiOn AnD SPECiFiCATiOn
2.1
introduction
Composite case with battery clip storage lugs and carry handle. Easy read, colour coded analogue gauge measures battery
condition and charge indicator. Test cycle button gives true battery indication. 230Volt charger with automatic power cut-off prevents
damage to battery whilst charging from the mains. Fitted with 12Volt power socket that will accept any 12Volt device with a cigarette
lighter type plug. Supplied with mains charger and double plug adaptor for in-car charging.
RS122 has Integral air compressor with pressure gauge for topping/pumping up tyres.
2.2
Specification
Models
Cold Cranking amps ...................................400A .................................................. 400A .......................... 12V - 1200A / 24V - 600A
Peak Amps .................................................900A .................................................. 900A .......................... 12V - 3000A / 24V - 1500A
Voltage ......................................................... 12V .................................................... 12V ..................................12V or 24V Switchable
Auxiliary Output ........................................... 12V .................................................... 12V ................................................................ 12V
Cable and Clamp Length ............................1mtr. ...................................................1mtr. ...............................................................1mtr.
Weight ......................................................... 10kg ................................................... 11kg ...............................................................15kg
Compressor ................................................... No .............................. Yes / Max. 100psi .................................................................. No
RS121
RS121
RS122
Original Language Version
RS122
RS125
RS125 Charging Socket
RS121, RS122, RS125
RS125
Fig.1
Issue: 3 - 08/04/10
Advertisement
