Advertisement
SIT-STAND DESK SYSTEM ACTIVE
OPERATION MANUAL
SAFETY AND WARNINGS
Inappropriate use of this product may cause property or bodily injury.
Check surroundings on all sides before using the desk. Do not place any objects taller than 540 mm
(3 level columns) or 620 mm (2 level columns) under the desk or frame. If the desk has additional
accessories, e. g. cable tray, evaluate if it fits before placing it on the desk.
Ensure the length of power cords are accounted for when operating the desk. Monitors, computers,
speakers, anything with a cord that is not long enough for the desk's range of motion could be pulled
down or have its wires broken. Check that no cables can get jammed.
Desks should not be used in environments with high humidity or dampness.
If you need to move the desk, DO NOT lift it only by holding the desktop. Lifting this way can stress
the fasteners connecting the frame to the desktop.
Please provide this operation manual to any users, installers, or support personnel operating the
product.
USAGE
The desk height is adjustable so the
desktop can be fixed for most suitable
user's position. These desks are
designed only for ergonomic sit-stand
position.
Do not move around, crawl or lie under
the desk frame.
Do not sit or stand on the desk frame or
desktop.
Any other use is at user's risk.
RESET
www.narbutas.com
SETUP AND
INSTALLATION
Choose a placement for the desk that
is a safe distance from window frames,
radiators, furniture etc.
Once the desk has been assembled,
adjust the feet so that the desk is level
and does not shift its position.
After this, connect the desk to the outlet
and the desk is ready for use.
For the first start of desk please press
and hold "down" button for control
box activation.
RESET
Two (2) level
Three (3) level
column:
column:
667-1137 mm
586-1236 mm
Limits (only with
button PA):
If the software version in the handset is
4.20 or later it has an editable memory
for high and low (stand and sit) position.
It could also be used to avoid collision
with i.e. a cabinet or pedestal. When a
memory position is set the desk will
stop when the memory position is
reached. To drive the desk outside the
memory position, press the up or down
button for a minimum of 5 seconds.
How to set memory/end positions:
1. Drive your desk to the level you want
to store.
2. Press both buttons 3 times
(0,5-1 second between each pressing).
3. Then press "up" or "down" to set the
position (0,5-1 second).
4. Do the same procedure for your
second store.
Advertisement
