Advertisement
4
INSTALL HANDLES
Turn VALVES (1) to off position.
Insert ADAPTOR (8) with larger diameter over the VALVE STEM (4).
Align LEVER (2) or WRIST BLADE HANDLE (3) and install onto VALVE STEM (4).
Insert BLUE INDEX (5) into cold valve (right side) and red INDEX (6) into
hot valve (left side).
Insert HANDLE SCREW (7) into HANDLES and tighten with screwdriver.
5
TEST INSTALLED FAUCET
Remove AERATOR.
With handle in OFF position, turn on water supplies and check
all connections for leaks.
Operate both handles to flush water lines thoroughly. Check
spout mounting and TEE connections for leaks.
Turn handles into OFF position and replace AERATOR.
6
SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove HANDLE and BONNET NUT.
Remove SPRING CLIP .
Lift STOP WASHER, turn 90° and replace.
Replace SPRING CLIP .
Replace BONNET NUT, HANDLE, SCREW, and INDEX.
AERATOR may accumulate dirt causing distorted and reduced water flow.
Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position.
Do not force - handles turn only 90°.
Plastic SCREEN in CARTRIDGE may accumulate dirt causing reduced water flow.
To clean, first turn off hot and cold water supplies, then:
Remove HANDLE and BONNET NUT.
Remove CARTRIDGE by pulling up.
Thoroughly rinse plastic SCREEN at base of CARTRIDGE.
Replace CARTRIDGE until flange is tight against valve body.
Turn valves OFF.
Replace BONNET NUT, HANDLE, SCREW and INDEX.
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
7
6
2
7
5
3
8
4
1
90°
STOP
WASHER
SPRING
CLIP
CARTRIDGE
SCREEN
AERATOR
60186 REV.1.7 (11/15)
Advertisement
