1. Manuals
  2. Brands
  3. Solaria Manuals
  4. Solar panel
  5. PowerXT-R-AC
  6. Mounting manuallines

Solaria PowerXT-R-AC Mounting Manuallines

Hide thumbs
1
2
3

Advertisement

Table of Contents

Redefining Home Solar
Quick Start Guide
Solaria PowerXT-R-AC Module Mounting
Guidelines
Important: This guide is not intended to replace the Solaria PowerXT-R-AC Module installation instructions. This is a
brief overview of the module mounting installation process. Always refer to the Installation manual for all safety and
proper installation methodologies.
Step 1. Plan and install the racking
Allowable rail locations with example of typical rail
configuration shown back of module view.
Step 2. Position the Enphase Q cable
A. Plan each cable segment to allow drop connectors
on the Enphase Q Cable to align with each AC
Module. Allow extra length for slack, cable turns,
and any obstructions.
B. Lay out the cabling on the racking for the AC branch
circuit. Make sure the cable is positioned in a way
that allows you to connect it to the microinverter.
Step 3: Connect the Enphase Q Cable into the junction box (Transition box to your homerun wiring)

Step 4: Terminate the Unused End of the Cable

Step 5: Ground the system

Quick Start – Solaria PowerXT-R-AC Module
© 2019 Solaria Corporation All rights reserved. Contents Subject to change.
12"
4" CLAMPING
AREA
FRAME
6" CLAMPING AREA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PowerXT-R-AC and is the answer not in the manual?

Questions and answers

Related Manuals for Solaria PowerXT-R-AC

Summary of Contents for Solaria PowerXT-R-AC

  • Page 1 Solaria PowerXT-R-AC Module Mounting Guidelines Important: This guide is not intended to replace the Solaria PowerXT-R-AC Module installation instructions. This is a brief overview of the module mounting installation process. Always refer to the Installation manual for all safety and proper installation methodologies.
  • Page 2 A. Place the modules on the roof. Do not place the modules in such a way that places pressure on the microinverter. Minimum distance from the top edge of the module to the rail should be about 12 inches. Quick Start – Solaria PowerXT-R-AC Module © 2019 Solaria Corporation All rights reserved. Contents Subject to change.
  • Page 3 There is an active “DC Resistance Low, Power Off” condition or “GFDI” fault. Solid red To reset, refer to “DC Resistance Low – Power Off Condition” below. The Microinverter LED Quick Start – Solaria PowerXT-R-AC Module © 2019 Solaria Corporation All rights reserved. Contents Subject to change.

Table of Contents