Table of Contents
Advertisement
Step 4
Install the installation kit (mounting side) onto the pole. Ensure that the top of the installation kit is flush
with the top of the positioning sticker.
A standard hose clamp is used for poles with a
diameter of 48 mm to 114 mm.
UP
Step 5
Install the installation kit (device side)
onto the switch.
Scenario 2: Wall Mounting
Before You Start
Ensure the wall is made of reinforced concrete and is able to bear at least 800 N. Ensure the wall can sustain a
tension of 1.25 kN exerted outwards vertical to the wall without being damaged.
Required Items and Tools
Protective gloves
Hammer drill
Phillips torque screwdriver (with a shaft of at least 130 mm in length)
Position the hose clamp around the pole and
feed the loose end of the hose clamp into the saddle.
Tighten the hose clamp around the pole and close
the hose clamp.
Tighten the screw on the hose clamp using the inner
hex torque screwdriver.
M4 (4 PCS)
1 N·m
Marker
Expansion bolts
Ladder
Socket wrench
An optional hose clamp is used for
poles with a diameter of 114 mm
to 380 mm.
M6
3 N·m
Step 6
Mount the switch onto the pole.
Spirit level
M6 inner hex torque screwdriver
5
M6 (1 PCS)
3 N·m
Advertisement
Table of Contents
