Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Petsafe sportdog SportHUNTER
Summary of Contents for Petsafe sportdog SportHUNTER
- Page 1 port HUNTER OWNERS MANUAL ����� ������ �� ����������...
- Page 3 SPORTDOG™ SPORTHUNTER 1200 REMOTE TRAINER INSTRUCTION MANUAL Thank you for purchasing the SportHunter 1200 Remote Trainer, one of the finest training systems available for training your dog. Three steps will prepare your system for use. Step I - Charge the Receiver Step II - Insert Battery into Transmitter Step III - Activate the Receiver Collar Please remember to fill out your warranty card before continuing.
-
Page 4: Initial Setup
INITIAL SET-UP Charger connector placed in receiver charging jack Step I - Charge the Receiver • Remove the rubber protection cap covering the charging jack on the SR-200I receiver. • Plug the charger into a standard 120V AC wall outlet. •... - Page 5 To turn off the receiver collar, again press and hold the activation switch for one second and release. The LED light will stop blinking and the receiver will “beep” twice, indicating that the unit has been turned off. Resetting the Receiver Note: Please make sure the receiver is charged before starting.
- Page 6 7. Loosen the contact points, remove the test wires, and securely tighten the contact points to the receiver. USING YOUR UNIT WEATHERPROOF Transmitter Your transmitter is easy to operate. It comes equipped with an internal antenna. No additional, external antenna is required. Several transmitter settings have been factory pre-set.
- Page 7 Programming the transmitter: • Remove the transmitter battery door. • Locate the small hole above the battery compartment. • Insert and depress a scribe or paperclip into the hole; observe the LED light. The LED light will blink to indicate in which of the seven modes (shown below) the transmitter is set.
- Page 8 Programming for Two Dogs Please program mode 5 or 6 into the transmitter (refer to the section titled “Programming the Transmitter”) before going any further. You can configure either receiver to the transmitter button of your choice. Receivers are programmed using the smaller black button and the larger yellow button located on the transmitter.
- Page 9 WATERPROOF Receiver Your dog responds to the transmitter’s stimulation through two contact points on the receiver collar that touch the dog’s neck. Therefore, it is important that the receiver is fitted properly onto your dog. The collar will fit a dog with a neck circumference measuring 9 to 22 inches. Fitting the SportHunter 1200 Remote Training Collar 1.
-
Page 10: Frequently Asked Questions
To begin, remove the collar from the receiver and then remove the four (4) screws shown in the picture. Take the top cover off the receiver and carefully remove the rechargeable battery pack by pulling on the wires disconnecting it from the connector. When placing the new battery pack into the receiver, make sure the connector of the rechargeable battery connector aligns with the... -
Page 11: Troubleshooting Guide
Q #5: How should I store the transmitter and receiver when I am not using them? A: Completely charge the receiver before storing. Turn the receiver off when not in use. Remove the battery from the transmitter. Store both at room temperature. To preserve the life of the receiver battery pack, charge it every 4-6 weeks when not in use. -
Page 12: Fcc Compliance
the repair or replacement of the product. Misuse, loss, or improper handling is not covered. Radio Systems Corporation will not pay for loss of time, inconvenience, loss of use of your product, loss of your product, or any incidental or consequential damages.
Need help?
Do you have a question about the sportdog SportHUNTER and is the answer not in the manual?
Questions and answers