Troubleshooting - Tetra FilterJet 400 Instruction Manual

Procedure:
Fig. G
1. Remove the filter sponge.
2. Twist the pump housing so that it detaches from the locking mechanism.
3. Remove the pump housing and impeller.
4. Remove the impeller from the filter housing and replace if required.
5. Clean all parts under running water.
– Rinse the filter sponge and gently squeeze it out several times.
6. Perform the procedure in reverse order to reassemble the pump.

TROUBLESHOOTING

If you are unable to rectify any faults yourself, contact your local retailer or Tetra
Customer Service.
Malfunction
Pump will not operate
Insufficient flow of
water
DISPOSAL
FilterJet 400/600/900 contains electronic components and therefore should
not be disposed of with standard household waste.
• Dispose of the device using the return system for your area so that the raw
materials can be recycled.
• Cut off all cables prior to disposal to prevent the device from being used.
Cause
Pump is not receiving
power
Pump is faulty
Blocked impeller
Pump is clogged up
Pump is faulty
Worn impeller
Solution
Connect the power
supply
Contact your retailer or
Tetra Customer Service
Clean the pump
Clean the pump
Contact your retailer or
Tetra Customer Service
Replace impeller
UK
15