Safety Instructions And Liability; Eu Declaration Of Conformity - Lamello Minispot G2A Operating Instructions Manual

English

Safety instructions and liability

Please also read the enclosed general safety instructions carefully before putting your grooving machine into
service.
- When the grooving machine is not in use, before all servicing work, before changing the cutter, etc.: unplug
the cable!
- Ensure that the machine is switched off before inserting the plug in the socket.
- Check plug and cable for damage before inserting. If damage is found, replacement must be made immediately by
a technician (cable type H07 RN-F).
- Make sure before starting the grooving machine that the rated voltage on the name-plate corresponds with the
mains voltage. The machine is only suitable for AC power supplies.
- The grooving machine is double-insulated and (conforming to CEE and VDE regulations) has a two-conductor cable
without ground conductor. The machine can be connected without risk to an ungrounded socket.
- Do not drill the motor case (e.g. to attach labels) since this damages the double insulation. Use only adhesive
labels for labelling.
- Clamp work tightly if possible
- Guide machine with both hands
- Use only perfectly sharpened cutters, since otherwise increased cutting forces may shift the work away.
- Use only cutters rated for manual feed.
- Do not stop the cutter after switching off.
- The baseplate must function satisfactorily, without jamming.
- The baseplate must not be clamped with the cutter driven out.
- The machine should only be used for the applications described in these operating instructions.
- Do not expose to rain or use in damp locations.
Manufacturer and retailer disclaim all product liability if the grooving machine is modified in any way from its original
state or condition as delivered, or if the grooving machine is used in a manner inconsistent with operating and safety
instructions.
EU-Declaration of Conformity
We declare under our sole responsibility that this product is in conformity with the following standards or normative
documents:
EN 55014, EN 55014-1/A1, EN 55014-2, EN 61000-3-2, EN 61000-3-3 in accordance with the regulations of direc-
tives 73/23/EEC, 89/336/EEC, 98/37/EG.
Sound emission and vibration acceleration
Typically A-weighted noise levels of the tool are:
Sound pressure level = 88 dB (A)
Sound power level = 101 dB (A)
Wear ear protection!
Typically the hand-arm vibration is below 2.5 m/s
Lamello AG
Holzverbindungstechnik
Hauptstrasse 149
CH-4416 Bubendorf
Lamello AG: Sitz Bubendorf, Gerichtsstand Liestal
Haftende Gesellschafterin: Lamello AG, Sitz Bubendorf, Gerichtsstand Liestal
Geschäftsführer: Herr Karl Steiner, stellv.: Herr Erich Zeller
10
2 .
K. Steiner E.Zeller