Forney IDD-II Manual page 2

IDD Flame Detector Heads Manual
372000-05 Rev J
INTRODUCTION
This manual contains information for the IDD Flame Detector Heads from Forney Corporation, 16479 N.
Dallas Parkway, Suite 600, Addison, Texas.
All personnel should become thoroughly familiar with the contents of this manual before attempting to
install, operate or maintain the system. Because it is virtually impossible to cover every situation that might
occur during operation and maintenance of the equipment described in this publication, personnel are
expected to use good engineering judgment when confronted with situations that are not specifically
mentioned herein.
The user should update this manual whenever significant changes are made to the system. To be of value,
the manual must always reflect the latest configuration of the equipment. It should be noted, however, that
Forney Corporation will furnish updated pages only if Forney authorizes a modification and accomplished
under Forney supervision.
PROPRIETARY NOTICE
The contents of this publication are proprietary data of Forney Corporation. Reproduction or use of any
part of the publication for purposes other than the support of the equipment for which it is published is
permissible only if expressly authorized in writing by Forney.
Additional copies of this publication may be purchased from Forney. When ordering or requesting cost
information, refer to the publication number appearing on the title page. Address to the attention of the
Sales Department, Forney Corporation, 16479 N. Dallas Parkway, Suite 600, Addison, Texas 75001.
Revisions
Revision Date
A
B
C 4/2003
D 6/2004
E 6/2004
F 10/2006
G 07/2013
H 08/2013
J 09/2015
Comments
Initial Release
Add CEX and Ultra versions of detector heads, update graphics.
Correct graphics with cable support brackets.
Update logo and address. Remove IDD-UV and IDD-UltraCEX
i