Table of Contents
Advertisement
Backlight time (Standby)
standby time, exit menu automatically after setup.
Press ↑/↓ key
increase and reduce standby time (10-60 seconds)
OK key to setup and return to Setup menu.
Press EXIT key to enter into the standby mode.
Unlock duration
Enter into unlock duration menu.
Select from 3s, 6s or 8s & confirm with OK.
Tamper alarm
Enter into Alarm settings menu.
Enable or disable the tamper alarm. It is suggested to enable it to be informed
when the outdoor unit is removed.
Language
Enter into Language menu.
Press ↑/↓ key
set up "Language"
Choose between German, Englisch, Spanish, French, Italian or Czech.
Press EXIT key to turn back to standby mode.
Pairing
1V1 Match code (put outdoor unit next to the Indoor monitor)
Select "Creating a network" on indoor monitor
the match code mode.
Meanwhile, long press the Reset on the outdoor unit, until you hear one "Beep"
sound, then release the reset.
Indoor monitor displays "Success", outdoor unit makes "Beep- Beep-Beep"
sounds, means matching successfully.
If matching failed in 16 seconds, indoor monitor shows "failed", the outdoor unit
makes "Beep" sound. Try steps from before again.
NOTE: By default, the monitor is paired with the outdoor unit.
Enter into Backlight Time menu to set up
press OK key to confirm and exit.
press OK key
1V2 - Match code
Choose "Give code (Start the network)" on the first indoor monitor
key
enter into "Start the network" mode.
press
On the new (second) indoor monitor enter into the network menu
"receive code" (Connect to network)
1V3 - Match code
Choose "Give code (Start the network)" on the second indoor monitor
OK key
enter into "Start the network" mode.
On the new (third) indoor monitor enter into the network menu
"receive code (Connect to network)
Add one more outdoor unit - Match code
Choose "Give code (Start the network)" on any one indoor monitor in system -》
press OK key
On the new (second) outdoor unit: Long press the "reset" until you hear "Beep,
Beep" sound. If match successfully, outdoor unit make three "beep" sounds, and
as No. 2 outdoor unit.
After all units receive code finished, please use the No. 2 outdoor unit call all
indoor monitors, if all code matched, receive code successfully; if not, repeat the
enter into
steps from before.
NOTE:
Inform function: after match code, give code, receive code, please
inform. Inform: tell all units the pieces and ID numbers in the system.
inform: outdoor unit calls all the indoor monitors (all indoor monitors should be
matched), if there are two outdoor units, use the No. 2 outdoor unit to inform.
NOTE:
The video door phone system support 2 outdoor units with 3 indoor
units at most (2V3).
the 2nd, then the 2nd give code to the 3rd.
outdoor unit.
press OK key.
press OK key.
enter into "Start the network" mode.
Giving code among indoor units should do from the 1st to
Any indoor unit can give code to the
press OK
choose
press
choose
Method of
Advertisement
Table of Contents
Need help?
Do you have a question about the TX-59+ and is the answer not in the manual?