Table of Contents
Advertisement
C R D
Software Configuration
The CRD1500-4000E appears to SPT 1500 terminals inserted into
the cradle as a dial-up PPP service. Therefore, just as you would
set up a Palm III terminal to connect to an Internet Service
Provider (ISP) like Compuserve or Earthlink, the SPT 1500
terminals must be configured for use with the cradle. This section
describes the steps necessary to configure both the SPT 1500
terminal and the CRD1500-4000E.
Installing NetSync
An SPT 1500 terminal must have NetSync installed and
configured for it to communicate with the CRD1500-4000E.
Additionally, NetSync extensions to the HotSync Manager must be
installed on the host system which the SPT 1500 terminal is to
synchronize with. The Network HotSync software is a free add-on
for the SPT 1500 and Palm Computing Platform series organizers
and is available from the PalmComputing website at http://
www.palm.com/custsupp/downloads/netsync.html. Please note,
in some later versions, such as Palm V, Network Hotsync is
included as part of the desktop software.
Follow the instructions to install the network HotSync software on
your host PC, then perform a HotSync to install the program on
your SPT 1500 terminal.
Configuring NetSync Options
Once NetSync is installed on your SPT 1500 terminal, it must be
configured for use with the CRD1500-4000E. From the HotSync
panel on your SPT 1500, select each of the option panels available
from the "Options" menu (accessed by tapping the Menu icon) and
configure them as follows:
1. To configure the Modem Sync Preferences:
a. Select the HotSync application from the main application
screen.
b. Select the menu icon to display the options menu.
1 5 0 0 - 4 0 0 0 E
8
Advertisement
Table of Contents
