Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Felisatti NTF250/1200ST
Summary of Contents for Felisatti NTF250/1200ST
- Page 1 NTF250/1200ST NTF305/1600ST...
-
Page 6: General Information
INTRODUCTION O Release lever Congratulations on your purchase of a new series P Base FELISATTI mitre saw, a high-quality product that will Q Support complete your set of professional tools. This new R Main body series represents the further evolution of the S Upper table locking knob renowned mitre saws developed by FELISATTI. -
Page 7: Technical Data
2.1 TECHNICAL DATA Model NTF250/1200ST NTF305/1600ST Tension and current V / A 230V-5,5A 230V-8A Frequency Absorbed power 1200 1600 Idling speed /min 4500 4000 Cut at 90°/crop (AxB fig. 3) 73x150 102x150 Cut at 45°/crop (AxB fig. 4) 73x90 97x102 Cut at 45°/blade at 45°... -
Page 8: General Safety Standards
lever switch. We recommend using this device only risk of electric shock. with the greatest caution. b) Avoid body contact with earthed or grounded Although this tool has been designed and surfaces such as pipes, radiators, ranges and constructed in order to permit operators to work refrigerators. -
Page 9: Installation
and do not allow persons unfamiliar with the power correspond to the indications provided on Plate A (fig. tool or these instructions to operate the power tool. 1). Before using any extension cables, make sure that Power tools are dangerous in the hands of untrained the section of the cable is adequate to its length and users. - Page 10 support and prevent the blade from coming into point for the turntable when the 45° reading on the contact with the turntable. turntable matches the same reference index on the WARNING! After this operation has been comp-leted, base. Repeat the operation at the symmetrical 45° make sure that the blade has not come into contact reading with the screw on the opposite side of the with the turntable and that the self-locking nut is...
- Page 11 does not provide shorter cutting times and can lead of steel and aluminium is absolutely prohibited. to diminished efficiency caused by the overloading of - Never use the tool to make slots. the motor. Proceed as follows to use the upper table: - Make 6.4.1 STARTING AND STOPPING THE BLADE sure that the switch is not locked in “ON”...
-
Page 12: Maintenance
HIGH SPEEDS. WARNING - An attachment that can be easily 8.2 REPLACING THE POWER SUPPLY CABLE connected to any Felisatti vacuum unit is provide to Make sure that the power supply cable is in good improve work conditions. condition; if worn, have it replaced by an authorised 7.3 CHECKING THE DRIVE BELT... -
Page 13: Problems-Causes-Remedies
DECLARATION OF CONFORMITY Jordi Carbonell Santiago Lόpez We hereby declare, under our sole responsibility, that the FELISATTI brand products described in this manual comply with the following standards or standard documents: Standard EN 61029, Machine Directive 98/37/EC and amendments, with 2006/95/ EC and 93/68/EEC, and in regard to electromagnetic compatibility, with Directive 89/336/EEC, EN 55014.1,... - Page 14 Interskol Power Tools S.L. Carretera de Sant Joan de les Abadesses s/n17500 RIPOLL, (Girona), SPAIN Tel +34972700200 Fax +34972700554 e-mail: felisatti@interskol.es...
Need help?
Do you have a question about the NTF250/1200ST and is the answer not in the manual?
Questions and answers