Table of Contents
Advertisement
Available languages
Available languages
5
Intended use
Mobile dust extractor suitable for
– Extracting dust up to 1 mg/m³ according to dust
class 'L',
– Extracting water,
– Increased loads during commercial use,
according to IEC/EN 60335-2-69.
The user is liable for improper or non-in-
tended use.
6
Operation
WARNING
Unauthorised voltage or frequency!
Risk of accidents
Observe the specifications on the machine's
name plate.
Observe country-specific regulations.
6.1
Initial operation
Insert the filter/disposal bag [2].
Attach the cord holder [3].
Connect the suction hose [4].
6.2
Connecting the mobile dust extractor
WARNING
Risk of injury from tools starting up unexpectedly
Before setting the switch to the "AUTO" or
"MAN" position, make sure that the connected
tool is switched off.
The switch [1-8] serves as an on/off switch.
Switch position "0"
Appliance socket [1-3] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-3] is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-3] is connected to the power,
the mobile dust extractor starts when the connect-
ed tool is switched on.
Insert the plug into an earthed socket.
Pull the plug from the socket when the ma-
chine is not in use and prior to maintenance
and cleaning work.
6.3
Connecting electric power tools
WARNING
Risk of injury
Observe the maximum appliance socket con-
nected load (see chapter "Technical data")
Switch off the electric power tool.
Connect the electric power tool to the appliance
socket [1-3].
Special features of CTL26 E SD
– CTL 26 E SD E/A: Socket module with automatic
switch-on function for the use of two electric
power tools: e.g. 2 sanders, 1 jigsaw + 1 sander
– CTL 26 E SD: Socket module with permanent
power supply for use as extension cable: e.g.
charger, lamp, etc.
6.4
Connecting pneumatic tools
WARNING
Risk of injury
Switch off the air tool.
Automatic on/off switch for air tools (CTL 36/48 E
LE, CTL 36/48 E LE AC or accessories)
with compressed air module in module slot [1-2]
Recommendation:
– Attachment of service unit VE (495886): com-
pressed air filtered and lubricated
– Use of IAS system with IAS connector (454757)
for Festool air tools
Requirement: tool with operating pressure of
6 bar!
6.5
Special features of the CTL 36 E AC- LHS
To use the mobile dust extractor in combination
with the PLANEX:
Use kink-resistant suction hose D 36 mm x 3.5
m-AS.
Use a special suction sleeve for connecting the
PLANEX.
Use closing slide CT-VS between the intake
opening [1-1] and suction hose.
Attach the tool holder.
Always use with a disposal bag!
7
Settings
7.1
Adjusting the suction power
Use the rotary knob [1-9].
CTL
GB
13
Advertisement
Table of Contents
