Table of Contents
Advertisement
Available languages
Available languages
6
Installation
The push-button interface has flexible connection lines
(0.75mm2) with cable end sleeves. Remove the rubber
caps that are on the end sleeves before connecting.
This allows connecting directly to the buttons used
according to the following diagrams.
The wiring for connecting the buttons is not to
be any longer than three meters.
If you do not use all channels, leave the rubber
caps on the cable end sleeves or the unused
channels.
The push button interface is only adapted for
connecting potential-free switches.
Do not connect the connection lines to mains
voltage!
25
Advertisement
Chapters
Table of Contents
