Product Overview; Controls - Toro 30632 Operator's Manual

Product Overview

1. Side-discharge chute
2. Mower deck
3. Recoil-start handle
4. Fuel tank

Controls

Become familiar with all the controls before you start
the engine and operate the machine.
Figure 3
5. Controls
6. Handle
7. Caster wheel
Control Panel
g012616
1. Throttle control
2. Key switch
3. Neutral/parking-brake lock
4. Operator-presence control
(OPC) lever
5. Handle
Throttle Control
The throttle control has 2 positions: F
(Figure 4).
Operator-Presence Control (OPC)
Levers
When you squeeze the OPC levers
the handles, the OPC system senses that you are in
the normal operating position. When you release the
OPC levers, the OPC system senses that you left the
normal operating position, and the system shuts off
the engine if either the gear-shift lever is not in the
N position or the blade-control switch (power
EUTRAL
takeoff) is engaged.
Gear-Shift Lever
The gear-shift levels allows you to shift to 5 F
positions, N
EUTRAL
(Figure 4).
Note:
It has an in-line shift pattern.
Important:
Do not shift while the machine is
moving, as you may damage the transmission.
9
Figure 4
6. Drive lever
7. Gear-shift lever
8. Choke
9. Blade-control lever (power
takeoff)
and S
AST
(Figure
position, and R
EVERSE
g001496
LOW
4) against
ORWARD
position