Figure 60
1. Bolt
2. Spacer
3. Locknut
4. Spring
4.
Place the spacer and spring onto the grass
deflector.
5.
Place the L-end of spring behind deck edge
(Figure
60).
Note:
Ensure that the L-end of the spring is
installed behind the deck edge before installing
the bolt as shown in
6.
Install the bolt and nut.
7.
Place the J-hook end of the spring around the
grass deflector
(Figure
Important:
The grass deflector must be
able to rotate. Lift the deflector up to the
fully-open position and ensure that it rotates
into the fully-down position.
5. Spring (installed)
6. Grass deflector
7.
L-end of the spring—place
behind the deck edge
before installing the bolt.
8.
J-hook end of the spring
Figure
60.
60).
Cleaning
Cleaning under the Mower
Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
g012749
3.
Raise the front of the machine using a jack and
use jack stands to support the machine.
4.
Clean the machine with a rag. Do not spray the
machine.
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
45