Checking For Fuel Leakage; Checking The Lubrication Of Body's Various Mechanisms; Checking The Spark Plug; Checking The Air Cleaner - Sym Fiddle III 50i CC Manual

§CHECKING FOR FUEL LEAKAGE§
 Check fuel tank, fuel cup, fuel hose, and carburetor for leakage.
§CHECKING THE LUBRICATION OF BODY'S VARIOUS MECHANISMS§
 Check the body's pivot points if they have enough lubrication.
(for example, the pivot points on the main stand, the side stand, and the brake lever...etc.).
§CHECKING THE SPARK PLUG§
 Remove the cap of spark plug cable (remove the spark plug using the
spark plug wrench in the tool kit.
 Check the electrode if it is dirty or fouled by carbon deposits.
 Remove the carbon deposits on the electrode with steel wire, and
clean the spark plug with gasoline, then, wipe dry with a rag.
 Check the electrode, and adjust its gap to 0.6~0.7 mm. (Check it with
a feeler gauge)
 Hand tight the spark plug as far as it can go and then tighten it another
1/2~3/4 turns with a wrench.
WARNING:
The engine is very hot after running. Pay attention not to get burned.
※ Use only spark plugs suitable for the engine specifications of this motorcycle recommended by the
manufacturer. (Refer to specifications.)
§CHECKING THE AIR CLEANER §
《DISASSEMBLE PRCEDURE》
1. Remove left frame body cover firstly.
2.Remove tapping screws from air cleaner cover.
3.Remove the air cleaner cover, remove the element
screws , then remove filter element.
4.Take the element out and clean it. (Refer to
maintenance schedule.)
《DISASSEMBLE PRCEDURE》
 Assemble the air cleaner in reverse order of disassemble.
CAUTION:
 Dust deposit is one of the major causes of reducing output horsepower and increasing fuel
consumption.
 Change the air cleaner element more frequently to prolong the engine's service life if the
motorcycle is driven on dusty roads very often.
 If air cleaner is installed improperly, dust will be absorbed into cylinders, which may cause a
premature wear and reducing output power and engine life.
 Be careful not to soak the air cleaner when washing the motorcycle. Otherwise, it will cause
engine hard to start.
Screws
20
0.6~0.7 mm
Element