Fakir S 20 OKO POWER Instruction Manuel page 35

Troubleshooting
Malfunctions
Appliance does
not work.
Appliance
suddenly stops
vacuuming.
Appliance does
not pick up dirt.
Appliance is
unusually loud.
AFTER USE
Possible cause
Appliance is not plugged
in or is not switched on.
No electricity at socket.
Power cord is damaged.
Overheating protection
was triggered. (Possibly
due to blocked hose or
tubes, dirty filters, etc.)
Dust bag is full.
Filters are dirty.
Nozzle, tube or hose is
blocked.
Air regulator is open.
Nozzle is not suitable for
the floor type.
Switch for carpet / hard
floor is not set for the floor
type.
Particles are blocking the
air path.
Remedy
Plug in the power plug and
switch on the appliance.
Test the vacuum cleaner on
another socket, where you are
certain that there is electricity.
Have the power cord replaced
by a Fakir / nilco service
center or a trained technician
in your country.
Switch off and unplug the
appliance. Eliminate the cause
of overheating (blockage,
dirty filters, etc.). Wait about
45 minutes. Once the appliance
has cooled, you can switch it on
again.
Replace the dust bag.
Clean or replace the dirty filter.
Remove the blockage.
Use a long wooden rod (e.g.
a broom handle), if necessary.
Close air regulator.
Attach the correct nozzle.
Set the switch for carpet / hard
floor for the floor type.
Remove the particles. Use
a long wooden rod (e.g. a
broom handle), if necessary.
GB
35