Wall Mounting - Adaptive Micro Systems Alpha 4000 RGB NEMA 12 Installation Manual

Wall mounting

Guidelines
Wall-mounting brackets and fasterners are provided with the sign. Hardware to secure the brackets to the wall will vary based
on the type of material (e.g., concrete, brick, wood) and are not included.
• The hardware for attaching to the mounting
surface must be rated for the mounting surface
and capable of supporting four times the weight
of the sign.
1. Begin by attaching the wall mounting backets (A)
to the sign using the four 10-32 x
screws (B).
• Torque to 24 lb-in.
B
A
2. Attach the two remaining wall mounting brackets
the mounting wall, verify the brackets algin with
the brackets on the sign.
4120 RGB NEMA 12
32.00"
4240 RGB NEMA 12
68.00"
3. Attach the mounting brackets (on each end of the
sign) to each other using the two 5/16-18 x
Philliphs screws (C) and the two 5/16 lock
washers (D) through the mounting holes as shown
below, secure with the two 5/16-18 nuts (E).
• DO NOT tighten the nuts at this time
Side View
A
D C
4000 RGB NEMA 12, I
A
LPHA NSTALLATION
/ " Phillips
3
8
B
A
/ "
3
4
Top View
C
E
D
. B)
M (PN 1778600401 R
ANUAL EV
• The wall (or a wall-mounted support system) must be
capable of supporting at least four times the weight of
the sign.
• Do NOT install directly to drywall, plasterboard, or
other fragile supports.
Match the alignment holes of the brackets on the
4.
sign with the holes of the brackets on the wall so
that the sign is at the desired viewing angle.
Fasten the mounting brackets together using the
5.
four 10-32 x / " Philliphs screws (F), the four #10
3
4
lock washers (G), and the four 10-32 lock nuts
(H) through the selected alignment holes on each
end of the sign.
• Torque to 24 lb-in.
Bracket alignment holes
H
6. Tighten the two 5/16 nuts (E), see Step 3 for
reference.
• Torque to 24 lb-in.
I
NSTALLATION
G
F
1-9