Table of Contents
Advertisement
Available languages
Available languages
Placing the unit
• Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the output
nozzle.
• Only install the machine on scratch resistant and water resistant surfaces. Do not orientate the escape nozzle
directly in the direction of the audience's eyes.
• To align the machine, release the fixation screws (6) at both sides, adjust the desired inclination angle and
retighten the fixation screws.
Filling the tank
Fluid handling
Always disconnect from the mains before filling the machine. Only use water-based fluids. We
recommend high-quality Eurolite snow fluids. Never add flammable liquids. Never operate without
snwo fluid. If fluid gets inside the machine, have it checked by skilled personnel before it is operated.
• Unscrew the tank cap and fill the tank (3) with snow fluid. Tightly close the tank again.
Use
• Connect the power cable to the machine (9) und plug the mains plug into a wall socket (230 V).
• Switching on the fans (2 + 5) causes a high starting current. Thus you should switch them on separately. First,
turn on the rear fan inside the snow cannon with the green button at the control unit (4). By pressing the red
button, the front fan is turned on and fluid is transported into the snow cannon. Adjust the output volume with the
valve (8) at the tank.
• After use you can turn off both fans with the green button. Prior to transportation, allow the machine to cool
down and completely empty the tank.
We recommend a frequent cleaning of the unit, in particular the output nozzle. Please use a soft lint-free and
moistened cloth for the outside of the unit. Never use alcohol or solvents! Unplug the machine before cleaning.
Do not allow the snow liquid to become contaminated. Always replace the caps on the liquid container and the
tank immediately after filling.
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are only
to be carried out by authorized dealers. Should you need any spare parts, please use genuine parts.
If defective, please dispose of the unusable device in accordance with the current legal regulations. Should you
have further questions, please contact your dealer.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating. Before replacing
the fuse, unplug mains lead.
Procedure:
• Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
• Step 2: Remove the old fuse from the fuse holder.
• Step 3: Install the new fuse in the fuse holder.
• Step 4: Replace the fuse holder in the housing.
Disposal of old equipment
When to be definitively put out of operation, take the product to a local recycling plant for a disposal
which is not harmful to the environment. Devices marked with this symbol must not be disposed of as
household waste. Contact your retailer or local authorities for more information. Remove any inserted
batteries and dispose of them separately from the product.
SETUP
WARNING!
CLEANING AND MAINTENANCE
PROTECTING THE ENVIRONMENT
14 • EN
Advertisement
Chapters
Table of Contents
