Fitting The Housing With Printed Circuit Board - DURKOPP ADLER 581 Additional Instructions

Fitting the sewing lamp

2.2 Fitting the housing with printed circuit board

Step
1. Place the housing (1) with preassembled printed circuit board under
Fig. 5: Housing with printed circuit board
①
②
(1) - Housing
2. Connect the X411 cable (3) to the tab connector of the printed circuit
Fig. 6: Connecting the cable
③
(3) - X411 cable
3. Secure the housing with the 3 screws ( 2.1 Removing components,
Additional Instructions 581 - 00.0 - 02/2015
the sewing head.
board (2).
pg. 5).
(2) - Printed circuit board
7