S&P CADB-N-D Installation Manual page 23

1. INTRODUCTION
Thank you for purchasing this appliance. It has been manufactured in full compliance with applicable safety regulations and EU standards.
Please read this instruction book carefully, as it contains important information for your safety during the installation, use and maintenance
of this product.
Keep it at hand for future reference.
Please check that the appliance is in perfect condition when you unpack it, as all factory defects are covered by the S&P guarantee.
2. SAFETY REGULATIONS AND "CE" MARKING
S&P technicians are firmly committed to research and development of ever more efficient products and in compliance with current safety
regulations.
The instructions and recommendations given below reflect current regulations, principally regarding safety, and therefore are based on
compliance with general regulations. Therefore, we recommend all people exposed to hazards to strictly follow the safety regulations in force
in your country. S&P will not be held liable for any possible harm or damage caused by non-compliance with the safety regulations, as well
as caused by modifying the product.
The CE mark and the corresponding declaration of conformity are proof of the product's conformity with current EU regulations.
3. GENERAL INSTRUCTIONS
A hazard analysis of the product has been carried out as provided in the Machine Directive. This manual contains information for all personnel
exposed to these hazards, with the aim of preventing possible harm or damage due to faulty handling or maintenance.
All maintenance operations (ordinary and extraordinary) must be carried out with the machine switched off and the electrical power supply
disconnected.
To avoid a possible accidental start up, place a warning notice on the electrical control panel with the following text:
Before connecting the power supply cable to the terminal strip, make sure the mains voltage corresponds to the voltage indicated on the
specifications plate of the unit.
Regularly check the product labels. If, due to the passing of time, they are no longer legible, they must be replaced.
4. UNIT LABELLING
The machine may come with several pictogrammes that must not be removed. These signs are divided into:
- Prohibition signs: Do not repair or adjust when in operation.
- Danger signs: Warning of the presence of live elements inside the container bearing the sign.
- Identification signs: CE card, indicating product information and manufacturer's address. The CE mark indicates the product's conformity
with EEC standards.
5. HANDLING
Before installing, make sure that the device to be used for moving and/or raising the product has sufficient capacity.
6. INSTRUCTION SYMBOLS
WATER
COIL
ELECTRIC
HEATER
"Attention: control disconnected for maintenance operations"
Danger signs
CENTRIFUGAL
FAN
DOUBLE
THICKNESS
ISOLATION
Prohibition sign
FILTER
DRAIN
23
EXHAUST AIR
FRESH AIR