Packing Contents; Tools Needed - Ryobi RBV-3350 Owner's Operating Manual

CAUTION. This packaging contains
sharp objects. Take care when
unpacking. Remove the machine,
together with the accessories supplied, from the
packaging. Check carefully to ensure that the
machine is in good condition and account for all the
accessories listed in this manual. Also make sure
that all the accessories are complete.

PACKING CONTENTS

• Blower/Vacuum Assembly
• Lower blower/vacuum tube
• Upper blower/vacuum tube
• Connection screw x 2
• Wheel
• Collection bag
• Harness
• Operator's manual.
WARNING. If any parts are damaged or
missing, do not operate this product until
the parts are replaced. Use of this
product with damaged or missing parts
could result in serious personal injury.
WARNING. Do not connect to power
supply until assembly is complete.
Failure to comply could result in
accidental starting and possible serious
personal injury.
WARNING. Do not attempt to modify this
product or create accessories not
recommended for use with this product.
Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious
personal injury.

TOOLS NEEDED

The following tools (not included) are needed for
assembly: Phillips Screwdriver
ATTACHING THE BLOWER/VACUUM TUBES
TOGETHER
WARNING. Never run the unit without
the blower/vacuum tube and collection
bag installed. Use of an improperly
assembled unit could result in serious
personal injury.
Fit guiding grooves on the lower blower/vacuum
tube into the upper section, Fig.1.
UNPACKING
If any parts are found to be missing, the machine
and its accessories should be returned together in
their original packaging to the retailer. Do not throw
the packaging away, keep it safe throughout the
guarantee period, then recycle if possible,
otherwise dispose of it by the proper means. Do
not let children play with empty plastic bags due to
the risk of suffocation.
ASSEMBLY
Push two sections firmly together until they click
into place. Use a connection screw in place A,
Fig.2, and fasten with a phillips screwdriver.
7
Fig. 1
A
Fig. 2