Table of Contents
Advertisement
3. DAILY OPERATION
3.1
On/Off switching
About
The PS24FHDCR monitor automatically turns on as soon as the power cord is connected to the mains
plug.
The monitor requires at maximum 30 seconds to power-up.
3.2
Status LED
About
During start-up, the monitor performs a self-test and sync-test before going into normal operation mode.
Depending on the test results, the status LED at the left side of the monitor will have a different color and
lighting duration. Below is an overview of the possible status LED modes:
Status
OFF
ON
ON
ON
ON
ON
ON
3.3
OSD menu use
To open the OSD menu
•
If the OSD is locked (default setting), first press and hold both the
3 seconds, until a pop up warns you that the OSD has been unlocked for about 20 sec. Afterwards,
press the
key to enter the OSD main menu.
Or,
•
If the OSD is not locked, press the
As a result, the OSD main menu comes up in the right bottom part of the screen. If no further actions are
taken within the following 15 seconds, the OSD menu will disappear and lock again if enabled.
K5902096 (451920611523) PS24FHDCR 08/03/2018
Color
N/A
ORANGE, static
ORANGE, blinking
RED, static
RED, blinking
GREEN, static
GREEN, blinking
key during normal operation.
3. Daily operation
Description
Monitor OFF
Monitor ON, Video sync OK,
default OSD settings
Monitor ON, powering on
Monitor ON, powering on, self-test
ON
Monitor ON, MAX brightness ON
Monitor ON, self-test FAILED
Monitor ON, Video sync OK,
settings different from default
brightness
Monitor ON, No video sync
and
keys for approximately
11
Advertisement
Table of Contents
