For Environmental Protection And Recycling Of Materials - Panasonic ES-SL33 Operating Instructions Manual

For environmental protection and
recycling of materials
This shaver contains a NI - MH battery.
Please make sure that the battery is disposed of at an
officially assigned location, if there is one in your country.
Disposal of Old Equipment and Batteries
Only for European Union and countries with recycling
systems
These symbols on the products, packaging, and/
or accompanying documents mean that used
electrical and electronic products and batteries
must not be mixed with general household waste.
For proper treatment, recovery and recycling of
old products and batteries, please take them to
applicable collection points in accordance with
your national legislation.
By disposing of them correctly, you will help
to save valuable resources and prevent any
potential negative effects on human health and
the environment.
For more information about collection and
recycling, please contact your local municipality.
Penalties may be applicable for incorrect disposal
of this waste, in accordance with national
legislation.
Note for the battery symbol (bottom symbol)
This symbol might be used in combination with a
chemical symbol. In this case it complies with the
requirement set by the Directive for the chemical
involved.
18
PB013084 - ES-SL33_(01)GB_ _05-13-16.indd 18
Disposal of the built-in rechargeable battery
Remove the built-in rechargeable battery before
disposing of the shaver.
Please make sure that the battery is disposed of at an
officially designated location if there is one.
This figure must only be used when disposing of the shaver,
and must not be used to repair it. If you dismantle the shaver
yourself, it will no longer be waterproof, which may cause it to
malfunction.
Remove the shaver from the AC adaptor.
Press the power switch to turn on the power and then keep
the power on until the battery is completely discharged.
Perform steps 1 to 6 and lift the battery, and then remove
it.
Take care not to short circuit the positive and negative
terminals of the removed battery, and insulate the terminals
by applying tape to them.






2016/5/17 9:01:14