Thermostatic Control - Celsius CELPH100 Operating Instructions Manual

Operating Your Heater
HEATER CONTROL SWITCH
Check that the heat control switch is set to Off position before plugging the heater into
the mains supply.
For greater economy, use the High Heat setting initially and then switch to the Low Heat
setting.
The power switches are located on the right hand side of the heater below the control
panel.
To turn the heater on, switch on the power switch to the heat setting desired.
To turn the heater off, switch off the power switches.
The control switch positions are:
0 = OFF
I = Low Heat
II = High Heat

THERMOSTATIC CONTROL

1. Rotate thermostat knob clockwise until you reach the maximum position.
2. When the room reaches a temperature that is comfortable for you, slowly turn the
knob anti-clockwise until the heater just turns off (you will hear a click).
3. The heater will now cycle on and off to maintain the comfort level you have set.
4. Take note of this setting position for future use.
HEATER CONTROL SWITCH THERMOSTAT