Advertisement
The length of cables to the receiver should be c. 9cm. We strip cables, tin-plate them and
we put the shrink- spaghetti insulation on them. We solder cables to the connector MPX,
strip the isolation with the hot-air gun and fix all with the fusing gun. We use the same work
procedure while soldering the connector MPX in the wing. We let the cabels so long that
their distance from the end of the wing is c. 3cm. And, beside the shrink- spaghetti
insulation, we pull on the silicone insulation on the cable too.
BackfireF5F
Picture 13: Connectors – wing/fuselage
Page 16
Advertisement
