Matching Transmitters; Conformity And Approval; Operation - Monacor JTS RU-8012DB/5 Instruction Manual

3.1 Matching transmitters

Model Type
Pocket transmitter with LED indication
and LC display, lavalier microphone
supplied
RU-850LTB / 5
can be configured either via the receiver
or via a separate menu
Wireless hand-held microphone with LED
indication and LC display
RU-850LTH / 5
can be configured either via the receiver
or via a separate menu
Pocket transmitter with LED indication,
lavalier microphone supplied
RU-850TB / 5
can only be configured via the receiver
Wireless hand-held microphone with LED
indication
RU-850TH / 5
can only be configured via the receiver

3.2 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the receiver RU-8012DB / 5 complies with
the directive 2014 / 53 / EU The EU declaration of
conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the fol-
lowing countries:
CZ
IT
In the Federal Republic of Germany, the receiver
requires a frequency assignment (for which a
fee is charged)
In other countries, it is necessary to apply
for a corresponding approval Prior to operating
the unit outside Germany, please contact the
MONACOR subsidiary or the corresponding
authorities of the respective country Links to the
national authorities can be found via the follow-
ing Internet address:
www cept org
tECC
tTopics
tOther spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
tEFIS and National Frequency Tables
14
DE EL FI
LT MT PL

4 Operation

1) Insert the antennas (4) provided into the
antenna jacks (8) and put them in a vertical
position
Hint: To increase the range and the interference
resistance, use antenna amplifiers from JTS (e g
UB-900I) The amplifiers are supplied with power
via the antenna jacks of the receiver
2) The output signals of the receiver units 1 (RX1)
and 2 (RX2) can be sent separately or as a
mixed signal to the subsequent audio unit
(e g mixer or amplifier) The following out-
puts are available:
– for each receiver unit, a balanced XLR out-
put (9) for connection to a microphone
input (in this case, activate the 20 dB atten-
uation:
units with line signal level
– for each receiver unit, an unbalanced
6 3 mm output jack (10) for connection to
an input for units with line signal level
If the 6 3 mm output jack RX1 is to provide
the mixed signal of both receiver units (in-
stead of the output signal of receiver unit 1),
set the selector switch "Mixed" (11) located
next to the jack RX1 to the position ON
3) For power supply, connect the power supply
unit provided to the power supply jack (13)
and to a mains socket (230 V/ 50 Hz) The
FR
receiver is provided with a strain relief (12):
Lead the cable around the hook at the bottom
of the housing to prevent accidental discon-
nection of the power supply unit from the
receiver
Note: The power supply unit will still consume some
power when the receiver has been switched off
Therefore, always disconnect the power supply unit
from the mains socket if the receiver is not operated
for a longer period of time
4) Use the rocker switch (7) to switch on the
receiver ( I = "on", O = "off")
☞ chapter 5 1 4) or to an input for