English - AEG DB17 Series Instruction Book

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

ENGLISH

Thank you for choosing an AEG product. In order to ensure the best results, always use original AEG accessories and
spare parts. They have been designed especially for your product. This product is designed with the environment in
mind. All plastic parts are marked for recycling purposes.
COMPONENTS
. Soleplate
A
. Maximum water level indicator
B
. Filling aperture with cover
C
. Spray nozzle
D
. Spray button
E
. Steam jet button
F
. Steam selector/Self-cleaning
G
Picture page 2-3
GETTING STARTED
1
Before first use. Remove all adhesive remains and gently rub with a dampened cloth. Rinse the water tank to remove
foreign particles. When turned on for the first time, temporary vapours/odours may occur.
2
Filling the steam iron with water. Make sure that the plug is removed from the power outlet. Turn the steam selector
to "OFF" and open the filling aperture cover (A). Using the beaker provided, pour water up to maximum level (B).
Raise the tip of the iron to prevent the water from overflowing while pouring. Close the cover (C).
This product is appropriate for use with tap water. It is recommended to use destilled water or a mix of 50%
destilled, 50% tap water.
3
Plug the power cable into a power outlet. Turn the temperature selector to the desired heat. The power indicator
light indicates that the iron is heating up. When the light turns off, the iron is ready to be used.
Note: If you lower the temperature during ironing, do not start again until the power indicator light turns on.
4
Iron with steam. Turn the steam selector to a position between "OFF" and "
required. To iron without steam, leave the steam selector on position "OFF".
Note: The iron gives off steam continuously if you hold it horizontally. Stop the continuous steam by placing the iron
vertically or turning the steam selector to "OFF".
5
Using the spray mist and steam jet function. Ensure that the water tank is at least 1/4 full. Use spray mist to pre-
dampen fabrics by pressing the spray button several times to release a fine mist (A). To use the steam jet function,
ensure that the tank is at least 1/2 full. Press the steam jet button several times to prime pump (B).
6
Steaming hanging items. The vertical steam jet function is ideal for steaming curtains, suits and delicate fabrics.
Hang the item on a hanger, hold the iron at a distance of 10–20 cm and press the steam jet button.
7
The appliance must be switched off before connecting or disconnecting the mains plug. Never pull the supply
cord. Instead, grasp the plug and pull. Empty the water tank and let the iron cool completely before storage.
CLEANING (DO NOT USE ANY DETERGENT)
8
Always store the iron on its heel rest with the cord twisted loosley around the cable wrap facility.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as these will dam-
age the surface.
9
Self-cleaning function. Hold the iron over a sink. Fill the filling aperture with water. Heat up the iron. Move the steam
button to self-cleaning position, hold for 60 seconds to empty water from the steam holes. Release the button to stop
the self-cleaning function.
10
Cleaning the soleplate. Do not use scouring pads or harsh cleaners on the soleplate as these will damage the
surface. To remove burnt residue, iron over a damp cloth while the iron is still hot. To clean the soleplate, simply wipe
with a soft damp cloth and wipe dry.
www.aeg.com
. Power indicator light
H
.
Mains cable
I
. Hot soleplate Indicator *
J
. Temperature selector
K
. Water tank
L
. Cable wrap facility
M
. Iron heel
N
(* Certain models only)
", depending on the quantity of steam
6

Advertisement

Table of Contents
loading

Table of Contents