Table of Contents
Advertisement
Section 5: Maintenance & Lubrication
Long-Term Storage
Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help to ensure the unit is
ready for field use the next time you hook-up to it.
!
DANGER
To avoid serious injury or death:
•
Always disconnect driveline from power take-off shaft
before servicing drivetrain and cutter blades. The power
take-off can be engaged if tractor is started.
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
!
WARNING
To avoid serious injury or death:
Always store cutter with 3-point hitch pivoted back as far as
possible. The floating 3-point hitch when not hooked to a
tractor can fall backwards unexpectedly causing bodily injury.
Clean, inspect, service, and make necessary repairs to
the cutter when parking it for long periods and at end of
working season. This will help ensure the cutter is ready
for field use the next time you hook-up to it.
1.
Clean off any dirt and grease that may have
accumulated on the cutter and moving parts. Scrape
off compacted dirt from the bottom of deck and then
wash surface thoroughly with a garden hose. A
coating of oil may also be applied to the lower deck
area to minimize oxidation.
2. Check blades and blade bolts. Replace if needed.
See "Cutter Blades" on page 34.
3. Inspect for loose, damaged or worn parts. Adjust or
replace parts as needed.
4. Repaint parts where paint is worn or scratched to
prevent rust. Ask your Land Pride dealer for aerosol
touch-up paint. Paint is also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the aerosol part number.
Land Pride Aerosol Touch-up Paint
Part No.
Part Description
821-011C
PAINT LP BEIGE SPRAY CAN
821-054C
PAINT MEDIUM RED SPRAY CAN
821-058C
PAINT GREEN SPRAY CAN
821-066C
PAINT ORANGE SPRAY CAN
821-070C
PAINT GP GLOSS BLACK SPRAY CAN
38
RCFM4014 Rotary Cutter 326-730M
Table of Contents
5. Replace all damaged or missing decals.
6. Lubricate as required. Refer to "Lubrication Points"
on page 47.
7.
Store unit on a level, clean, dry surface. Inside
storage will reduce maintenance and extend its life.
8. Follow all unhooking instructions on page 32 when
disconnecting tractor from cutter.
Order Replacement Parts
Land Pride offers equipment in factory standard Beige
with black highlights. This implement may also be
purchased in Orange, Green, or Red.
When ordering an optional color, the suffix number
corresponding to the color must be added at the end of
the part number. Parts ordered without the suffix number
will be supplied in factory standard colors.
81 . . . . . . . Green
82 . . . . . . . Orange
For example, if you are ordering a replacement part with
part number 555-555C and the existing part is orange,
then add the suffix 82 to the end of the number to make
the part number read 555-555C82.
83 . . . . . . . Red
85 . . . . . . . Black
8/11/14
Advertisement
Table of Contents
