Disposal Information; Troubleshooting; Specifications - Bahco BBCE24-10 Manual

16. DISPOSAL INFORMATION

Do not dispose of this product with other household waste. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, and
to promote the sustainable reuse of material resources, recycle it responsibly. To
discard your used device, please use the return and collection systems or contact
the retailer where the product was purchased, for environmentally-safe recycling.

17. TROUBLESHOOTING

PROBLEM
Battery connectors do not spark
when touched together.
The charger will not turn on
when properly connected.
I cannot select a language on
the display.
Green LED is lit and the display
shows ANALYZING BATTERY.
Green LED is flashing and
the display shows CHARGE
ABORTED-BAD BATTERY.
The display shows CONNECT
CLAMPS.

18. SPECIFICATIONS

Input .................................................................................................. 230V AC~50Hz, 3.2A
Output ............................................................................................................... 24V
Ingress Protection rating ..............................................................................................IP20
19. REPLACEMENT PARTS
Battery clamps (quick-connect).............................................................................BBCEC2
Ring connectors (quick-connect) ..........................................................................BBCER2
POSSIBLE CAUSE
The charger is equipped with an auto-
start feature. It will not supply current to
the battery connectors until a battery is
properly connected. The connectors will
not spark if touched together.
AC outlet is dead.
Poor electrical connection.
Press the button for 5 seconds to select
a language:
(EN-FR-ES-DE-SE-ITA).
The charger needs to check the
condition of the battery.
The battery is too large for the charger.
The battery voltage is still below 20V
after 2 hours of charging.
The clamps are not making a good
connection.
The fuse is bad.
•
11
REASON/SOLUTION
No problem; this is a normal condition.
Check for open fuse or circuit breaker
supplying AC outlet.
Check power cord and extension cord
for loose fitting plug.
No problem; this is normal.
The green LED will be lit when the
charger is checking the condition of the
battery. This is normal.
You need a charger with a higher amp
rate.
Have the battery checked.
Check for poor connection at battery
and frame.
Replace the in-line fuse for the ring
connector.
•
10A