Table of Contents
Advertisement
The permissible limit values are observed
provided that:
The mains power supply equipment and
R
the charging cable are not damaged.
The instructions for handling the charging
R
cable and controls on the charging cable
have been followed.
If the charging cable or charging cable
#
connector becomes too hot, have the
power supply equipment of the mains
supply checked.
* NOTE Damaged or dirty vehicle socket
Always keep the socket cover and the
#
socket flap closed when there is no
charging cable connected. This protects
the vehicle socket from dirt and dam‐
age.
Make sure that the socket cover is
#
closed properly before closing the
socket flap. This can otherwise result in
damage which may prevent the socket
flap from being opened again.
Requirements:
The transmission is in position j.
R
The ignition is switched off.
R
The vehicle is unlocked.
R
The charging cable is not taut.
R
Driving and parking
Press socket flap 1.
#
Socket flap
1
swings open.
Press catch
3
to the left.
#
Socket cover
5
is open.
To charge at a mains socket (mode 2):
#
insert the mains plug into the mains socket
of the external power source to the stop.
Set the maximum charging current if
#
required.
Insert the charging cable connector into vehi‐
#
cle socket
2
to the stop.
Make sure that the charging cable is not taut
when inserted.
Indicator lamp
4
first flashes orange and
then green as soon as the high-voltage bat‐
tery is being charged.
To charge at a wallbox/charging station
#
(mode 3): insert the charging cable connec‐
tor into vehicle socket
2
to the stop.
Make sure that the charging cable is not taut
when inserted.
37
Hide quick links:
Advertisement
Table of Contents
