Table of Contents
Advertisement
7.
TROUBLE SHOOTING
Fault
Pressure drop in the tank.
Pressure switch valve leaks when compressor is idle.
Compressor stops and does not restart.
Compressor does not stop at max pressure.
Compressor does not reach max pressure.
Compressor noisy with metallic knock.
IMPORTANT WARNING - Air contaminants taken into the compressor will affect optimum performance.
Example: Body filler dust or paint over-spray will clog the pump intake filter and may cause internal
damage to pump/motor components.
Please note that any parts damaged by any type of contamination will not be covered by warranty.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Cause
Air leaks at connections.
Non-return valve seal defective.
Power failure.
Motor failure.
Pressure switch fault.
Filter clogged.
Head gasket or valve fault.
Low oil level.
Bearing or piston damage.
Environmental Protection
WEEE Regulations
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Remedy
Run compressor to max. pressure, switch off.
Brush soap solution over connections and look for
bubbles. Tighten connections showing leaks.
If problem persists contact Authorised Service Agent.
Discharge all tank pressure. Referring to fig.6,
unscrew valve cap 'A'. Clean rubber disc 'B' and its
seat. Refit all parts accurately.
Check electricity supply and fuse.
Contact Authorised Service Agent.
Contact Authorised Service Agent.
Replace filter element.
Contact Authorised Service Agent.
Turn off and top up oil immediately.
Contact Authorised Service Agent.
www.sealey.co.uk
01284 757500
sales@sealey.co.uk
01284 703534
SACV42755B,ASACV45775B Issue: 1 - 17/12/14
Advertisement
Table of Contents
