Care, Cleaning And Storage - Breville Ikon BGR400 Instructions Manual

Care, cleaning and storage

Before cleaning, switch the power off at the power
outlet and then remove the plug. Allow your smart
Ikon Grill to cool before cleaning. The appliance is
easier to clean when slightly warm.
Always clean your Ikon Grill after each use to
prevent a build up of baked-on foods.
Wipe cooking plates with a soft cloth to remove food
residue. For baked on food residue follow "using the
plate release feature" page 9, remove the grill plates
from the grill for cleaning. Wash in hot soapy water.
Remove stubborn residue with a non abrasive plastic
scouring pad or nylon washing brush. Rinse and dry
thoroughly with a clean, soft cloth and replace.
The cooking plates are coated with a non-stick
surface, do not use abrasives.
Do not use spray-on non-stick coatings as this
will affect the performance of the non-stick
surface on the cooking plates.
Cleaning the drip tray
Remove and empty the Drip Tray after each use and
wash the tray in warm, soapy water. Avoid the use of
scouring pads or harsh detergents as they may
damage the surface.
Rinse and dry thoroughly with a clean, soft cloth
and replace.
DO NOT IMMERSE ANY PART OF THE BREVILLE IKON GRILL IN WATER OR
ANY OTHER LIQUID.
14
All manuals and user guides at all-guides.com
Note
Note
Quantanium scratch resistant coating
Your Ikon Grill features a special scratch resistant
non-stick coating that makes it safe to use metal
utensils when cooking.
Regardless of this fact, Breville recommends that
care is taken with the non-stick coating particularly
when using metal utensils.
Do not use sharp objects or cut food inside the
Ikon Grill. Breville will not be liable for damage to
the non-stick coating where metal utensils have
been misused.
Cooking on a non-stick surface minimises the need
for oil, food does not stick and cleaning is easier.
Any discolouration that may occur will only detract
from the appearance of the Ikon Grill and will not
affect the cooking performance.
When cleaning the non-stick coating, do not use
metal (or other abrasive) scourers. Wash in hot soapy
water. Remove stubborn residue with a non abrasive
plastic scouring pad or nylon washing brush.