Advertisement
ICWUSA.com, Inc.
ATTACH VESA
TO MONITOR
Using a phillips
screw driver,
attach the VESA
plate to the back
o f y o u r L C D
monitor.
ADJUST BALL VESA
TENSION & HEIGHT
Use the slider knob
to loosen the slider to
adjust the height of the
monitor on the Paralink.
Adjust the pivot tension
of the ball by gently
and evenly tightening
or loosening the four
screws on the back of
the ball VESA.
ATTACH THE THBV HANDLE
page 2
MD ARM INSTALLATION INSTRUCTIONS
Slider Knob
Pivot tension
adjustment
screws
The THBV is attached
to the Paralink and
Quicklink
by
two
screws on the back of
the VESA plate.
If you have any questions, please call 1-800-558-4435
ADJUST
PARALINK TILT
Adjust Monitor to desired
position with ball VESA.
Tilt your monitor 50°
in any direction. Adjust
your monitor between
portrait and landscape
by rotating ball VESA.
Adjust monitor depth
by moving the paralink
forward or back then
t i g h t i n g t h e d e p t h
adjustment knob.
Screw
to attach
handle.
MD ARM INSTALLATION INSTRUCTIONS - rev 11/13/2012 mf
Depth
Adjustment
Knob
Screw
to attach
handle.
Advertisement
