Front Panel At Power-Up - Tektronix Phaser 220e User Manual

2
Getting Set Up

Front panel at power-up

All indicators light briefly and immediately go out, except POWER and
READY, which remain on for about 10 seconds. Then the READY indicator
blinks while the POWER indicator remains on and the self-tests are run.
When both POWER and READY are on steady (not blinking), the self-tests
are complete.
ERROR JAM MEDIA RIBBON COVER READY POWER
8869-26
When a standard transfer roll is more than 75 percent used up, the front-panel
RIBBON indicator lights, reminding you that it is time to order a new
transfer roll.
When you install the sample transfer roll supplied with the printer, the
RIBBON indicator may light as soon as you install it, or after you make a
few prints. This is because the sample transfer roll contains a limited number
of prints.
For complete information on the front-panel indicator lights, refer to "Front
panel (Phaser 220i and Phaser 220e)" on page 7-6.
2-20
Phaser 220i and Phaser 220e Color Printers