Ethertalk Configuration Overview; Before You Begin; Using Appletalk Phase 2 - Tektronix 200 Series User Manual

Chapter
3

Before you begin

Using AppleTalk Phase 2

EtherTalk Configuration
(Macintosh)
Before you begin the EtherTalk conÞguration, make sure that you have
completed the following steps:
Your printer should be set up, connected to the network, and
turned on. See your printerÕs user manual for information about
setting up and turning on the printer. For information about
connecting the printer to the network, see ÒEthernet connectionÓ
on page 2-6.
The Tektronix driver for your printer should be installed on every
Macintosh and PC that will send print jobs to the printer. For
details on driver installation, see the manual that is shipped with
your printer drivers and utilities diskettes.
If you connect the printer using EtherTalk, your computer must have
AppleTalk Phase 2 software. If you connect the printer using LocalTalk,
AppleTalk Phase 2 is not required (Phase 1 will work).
3-1
User Manual