Continuous Drainage - Challenge MDN4-12DEN3-QA3 Instruction Manual

DRAINAGE
While the water tank is full, the compressor will stop and the unit will display "P2" , the
water full indicator light(Red) will illuminate.
To remove the water tank, pull it out carefully from the unit.
After empting the water tank, place the tank back to the unit. Make sure it is properly
positioned, in order for the water full indicator light(Red) to go out and your dehumidifier
is ope rating.
Please note, in case, the water tank has not been positioned well, the water full indicator
light(Red) will still illuminate.
1. Pull out the bucket a little.

CONTINUOUS DRAINAGE

When the dehumidifier is operated at very high humidity levels, the water tank will
require more frequent drainage. In this situation, it may be more convenient to set the
unit up for continuous drainage with the following procedures:
1 . Cut off the plastic cover located at drain hose outlet by a scissor. Remove the rubber water
stopper in the drain hose outlet. Keep the rubber water stopper in a safety place for future use.
2. Prepare the water tube (not included) with 13.5 mm internal diameter and 1.5 mm thickness.
3. Connect the tube to the drain hose outlet at the back.
4. Ensure the water will always drain away freely and the tube will remain in right place & the
water tank is in correct position.
NOTE: In very cold weather conditions, precaution should be taken to prevent the water tube
from freezing.
If it is no longer to use the continuous drainage, please follow the below procedures :
1. Remove the water hose from the drain hose outlet of the unit.
2. Insert the rubber water stopper to the drain hose outlet.
Cut off the plastic
cover, then attach
the water hose to
the drain hose outlet.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit. And pour the
water out
Do not block water flow by a rise.
7
Do not block water flow by a retortion.