Machine Features; Intended Use; Operation; Service And Maintenance - Festool TCL 3 Original Operating Manual

TCL 3
GB
4

Machine features

[1-1] Holder for battery pack
[1-2] LED-Display
[1-3] Cable holder
[1-4] Battery pack
[4] Wall mount for charger
The specified illustrations appear at the beginning
of the Operating Instructions.
5

Intended use

Charger TCL 3 is suitable for
– charging battery packs: Protool BP, Festool BPS
and BPC (NiMH, NiCd, LiIon are recognised auto-
matically.)
NiCd 12.0 V, 15.6 V
NiMH 12.0 V, 15.6 V
LiIon 10.8 V (3S1P)
10.8 V (3S2P)
14.4 V (4S1P)
14.4 V (4S2P) 2.6 Ah, 3.0 Ah, 4.2 Ah, 5.2 Ah
18.0 V (5S1P)
18.0 V (5S2P) 2.6 Ah, 3.0 Ah, 4.2 Ah, 5.2 Ah
– indoor use only.
– do not recharge no-rechargeable batteries.
The user is liable for improper or non-in-
tended use.
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident

The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.

In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
6.1 Charger cable holder [1-3]
Unwind the cable completely from the recess
before using the charger.
6.2 Changing the battery pack [2]
Removing the battery pack[2 B]
Inserting the battery pack [2 A]
10
2.4 Ah
3.0 Ah
1.3 Ah, 1.5 Ah
2.6 Ah, 3.0 Ah
1.3 Ah, 1.5 Ah
1.3 Ah, 1.5 Ah, 2.6 Ah
6.3 Charging the battery pack [3]
If a warm NiMH battery pack (> 37 °C) is inserted,
the pack is charged with a reduced charging cur-
rent and will take longer to charge.
The LED [1-2] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Charging battery pack at maxi-
mum rate.
LED green - flashing slowly
Charging battery pack with
reduced current, begins at 90%
battery level.
LED green - lit continuously
Charging process is complete or
will not resume because the cur-
rent battery level is above 90%.
LED red - flashing
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
the permitted range.
7

Service and maintenance

Observe the following instructions:
– Keep the contacts on the machine, charger and
battery pack clean.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
8 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.