Step By Step Installation - JBL ProFlora u401 Instructions For Use Manual

passive reactor JBL ProFlora Taifun
10 CO
2
11 TopStop CO
12 CO permanent test JBL Test Set permanent CO
2

12.1 Step by step installation

1. For the m601 – m603 and m1003 sets first attach the extensions to the JBL Taifun CO
Passive Reactor (10) according to the height of the aquarium. Rinse the reactor in lukewarm
water and place it vertically in the aquarium in a location with a slight current of water. The
upper edge should be approx. 2 cm under the surface of the water. The slits of the individual
modules should be as clear as possible from obstruction by plants or decorations.
2. Installation WITHOUT a bubble counter (8):
Cut off the C hose (11) with scissors about 30 cm from the upper end of the reactor and
2
plug the free ends of the hose onto the hose supports of the non-return valve (9). Check
the direction of flow. If an unobstructed view of the reactor so as to monitor the number of
bubbles is not possible, install the bubble counter (8) as described under Item 4. When doing
so, it is imperative to make sure that the non-return valve (9) between the pressure reducer
or, as applicable, the pH control and the bubble counter is positioned correctly.
3. Install the CO
2
4. Installation WITH a bubble counter (8):
Select a suitable place to fit the bubble counter, where it can be easily observed. Install the
bubble counter (8). The bubble counter can either be attached using suction pads (e.g. to
the outside of the aquarium) or to a wall or surface of a piece of furniture with the enclosed
screws. Cut the CO
connections of the bubble counter. Check that the supply hose is attached to the connection
hose JBL ProFlora T3
2
permanent test (12) in the aquarium according to the enclosed instructions.
hose to the correct length and attach the free ends to the hose screw
2
plus pH
2
UK
2
21