Advertisement
5
Add the system to the network
Your service provider should have provided you with the information you need
to get on-line.
For H.323 type of communication, this will include such things as system
name, H.323 alias, gatekeeper address, etc. For SIP type of communication,
similar type of information will be supplied.
For networks administrated through TMS (TANDBERG Management Suite),
your TMS administrator will be able to assist you when configuring.
The H.323 and SIP settings are configured from the Advanced
configurations menu:
1.
Navigate to Settings > Advanced > Advanced Configuration and select
H323 or SIP
2.
Expand the items in need of modification and enter the information
supplied by your service provider.
6
Verify your settings
We strongly recommend that you verify the settings by inspecting the System
Information list.
You do this by accessing the System Information in the same way as you did when
you verified you IP address setting.
Go to System Information to verify the settings:
1.
Navigate to Settings > System Information
2.
Verify the previous configurations. For example, if you successfully registered
to a SIP server the Status will show Registered. If the registration failed the
Status will show Not registered.
3.
Press Home (
) to exit.
D1451302
(11983304 as printer firendly version June 2010)
Installing the TANDBERG Quick Set C20
7
8
Set the time and date
Verify the date and time to see if the time zone settings need to be adjusted.
The date and time is located in the upper right corner on screen.
Go to the Time settings to set the date and time:
1.
Navigate to Settings > Date and time
• If you configure Set date and time to Auto:
• Select the GMT time zone from the list and a select format for the
date and time.
• If you configure Set date and time to Manual:
• Set the date, month, year, time and select a format for the date and
time.
2.
Press Save to save the changes, or Cancel to leave without saving.
Set the administrator settings menu password
By default the administrator password is blank.
It is highly recommended to define a password to access the administrator
NOTE!
settings menus. Changing these settings may affect the behavior of the system and
should be done by the system administrator.
When you define or change the administrator password make sure you save a
NOTE!
copy of the password in a safe place.
Define the password:
1.
Navigate to Settings > Advanced > Change password
2.
On the remote control, press the # key to toggle between lower or upper case
characters and numbers: abc/ABC/123
3.
Enter the password. The password you enter is hidden, as each character is replaced
with a star (*).
4.
Press Save to save the changes, or Cancel to leave without saving.
5.
Press Home (
) to exit.
6
Advertisement
