Table of Contents
Advertisement
FlexiDome Corner Mount
3
Installation
This installation should be made by qualified service personnel and conform to the National
Electrical Code and applicable local codes.
3.1
Installing the Corner Mount
Figure 3.1 Corner Mount Disassembly
1
2
3
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Install the camera dome housing cover.
11. Connect all wires to camera.
12. Pull any excess wires back into mount.
13. Slide front cover [1] onto rear cover [2] and secure with security screw [3].
Bosch Security Systems
1
Front cover
Rear cover
Security screw
Disassemble housing by releasing security screw [3] on bottom of unit using provided
security wrench, then pull front cover [1] off rear cover [2].
Determine location for corner mount.
Using rear cover [2] of mount as template, mark location of mount holes on walls.
Drill holes for anchors and install anchors into wall.
Decide which conduit hole to use and plug remaining openings using two (2) plugs
(provided with hardware kit). Secure conduit plug on top of unit by tightening set screw
on back of rear cover [2]. This step must be performed before rear cover [2] is secured
to wall. Use a 2.5 mm Hex Key (not supplied).
If a side feed-through is chosen, mark hole using rear cover as template. Drill hole into
wall. Use this hole to pull wires into bracket.
Assemble rear cover [2] of mount to wall.
Pull all wires from wall through feed-through hole.
Assemble camera to front cover [1] and fix with three (3) M5 screws (supplied).
Installation manual
3
Installation | en
5
2
| v2.0 | 2011.08
Advertisement
Table of Contents
