Asus TUF Gaming X570-Plus Manual page 26

4. USB 2.0 connectors (10-1 pin USB78; USB910)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mb/s connection speed.
TUF GAMING X570-PLUS USB 2.0 connectors
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
5. USB 3.2 Gen 1 connector (20-1 pin U32G1_12)
This connector allows you to connect a USB 3.2 Gen 1 module for additional USB
3.2 Gen 1 front or rear panel ports. With an installed USB 3.2 Gen 1 module, you can
enjoy all the benefits of USB 3.2 Gen 1 including faster data transfer speeds of up to
5 Gb/s, faster charging time for USB-chargeable devices, optimized power efficiency,
and backward compatibility with USB 2.0.
TUF GAMING X570-PLUS USB 3.2 Gen 1 connector
The USB 3.2 Gen 1 module is purchased separately.
The plugged USB 3.2 Gen 1 device may run on xHCI or EHCI mode depending on the
operating system's setting.
1-12
USB78 USB910
PIN 1 PIN 1
U32G1_12
PIN 1
Vbus
IntA_P2_SSRX-
IntA_P2_SSRX+
GND
IntA_P2_SSTX-
IntA_P2_SSTX+
GND
IntA_P2_D-
IntA_P2_D+
Chapter 1: Product Introduction
Vbus
IntA_P1_SSRX-
IntA_P1_SSRX+
GND
IntA_P1_SSTX-
IntA_P1_SSTX+
GND
IntA_P1_D-
IntA_P1_D+
GND