Table of Contents
Advertisement
CAUTION!
Do not use abrasive
materials or steel wool to
clean the drum.
10.6 Cleaning the control
panel and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
11. TROUBLESHOOTING
Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
Possible cause
1)
The tumble dryer is not connected
to the mains supply.
The door is open.
The Marche/Arrêt button was not
pushed.
The Départ/Pause button was not
touched.
The appliance is in standby mode.
Incorrect programme selection.
The filter is clogged.
Séchage option was set to
prêt à repasser .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
10.7 Cleaning the airflow slots
Use a vacuum cleaner to remove fluff
from the airflow slots.
4)
CAUTION!
Do not use furniture
cleaning agents or cleaning
agents which can cause
corrosion.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do-
mestic installation).
Close the door.
Push the Marche/Arrêt button.
Touch the Départ/Pause button.
Push the Marche/Arrêt button.
Select a suitable programme.
3)
Clean the filter.
Change Séchage option to a high-
er level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
ENGLISH
21
2)
5)
3)
Advertisement
Table of Contents
