Troubleshooting - AEG TR7C40588 User Manual

10.5 Cleaning the drum
WARNING!
Disconnect the appliance before you
clean it.
Use a standard neutral soap detergent to
clean the inner surface of the drum and drum
lifters. Dry the cleaned surfaces with a soft
cloth.
CAUTION!
Do not use abrasive materials or steel
wool to clean the drum.
10.6 Cleaning the control panel and
housing
Use a standard neutral soap detergent to
clean the control panel and housing.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 Error Codes
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists, contact the
Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an error
code and the Start/Pause button may flash continuously:
Error code
Appliance motor overloaded.
E50 Too much laundry or entrap in the drum.
Internal fail. No communication between
electronic elements of the appliance.
E90 or E91
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
Do not use furniture cleaning agents or
cleaning agents which can cause
corrosion.
10.7 Cleaning the airflow slots
Use a vacuum cleaner to remove fluff from
the airflow slots.
Possible cause
CAUTION!
Remedy
The programme was not completed. Re‐
move the laundry from the drum, set the
programme and restart the cycle.
The programme was not finished properly
or the appliance stoped too early. Switch
the appliance off and on again.
If the error code appears again, contact the
Authorised Service Centre.
ENGLISH 21