Interconnection Example 4-Channel-Mode: 1 X Stereo System (Front) And 1 X Stereo System (Rear) - MB QUART Nano NSC 2100 Installation Manual

INTERCONNECTION EXAMPLE 4-Channel Mode: 2 x Stereo System (Front & Rear)
Loudspeaker
front / left
2 – 8 Ohms
FUSE
GND REM 12V
POWER
PROTECT
POWER INPUT
Loudspeaker
rear / left
2 – 8 Ohms
INTERCONNECTION
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
• If there is only one stereo signal with two jacks available, you must use two y-connectors to splice the signal.
• Connect the front- and rear speakers with the speaker outputs (SPEAKER OUTPUT + 1CH -, + 2CH - and + 3CH -, + 4CH -).
• Ensure by any means, that the total impedance load of all speakers is not lower than 2 ohms per channel.
Too low impedance cause high temperature and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
CROSSOVER SETTINGS CH1/2 & CH3/4
• For bigger speakers (more than 20cm) you can set the X-OVER switch to the FULL position (Full Range Signal).
• For smaller speakers (8.7cm - 16cm) you must set the X-OVER switch to the HP Position (Highpass Mode) to avoid any damage
by lower frequencies on the speakers. The cut-off frequency is adjustable with the HIGH PASS controller and should be set between
60Hz to 150Hz, depending on the size of the speakers.
• The LOW PASS Controller is not in use in this interconnecting example.
LEVEL INPUT CONTROLLER CH1/2 & CH3/4
• Turn the INPUT LEVEL controller of the amplifier to the 6V position.
• Turn the volume controller of the headunit to 80 - 90% of its full setting.
• Turn the INPUT LEVEL controller clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL controller slightly until you hear a cleaner sound.
BASS BOOST CONTROLLER
• The BASS BOOST controller must be turned to 0 dB position in this interconnecting example .
REFERENCE NOTE
Do not connect loudspeaker cables with the vehicle's chassis. Always ensure the correct polarity of all connections. The
interchange of plus and minus cause total loss of bass playback and could damage the speakers.
Loudspeaker
front / right
2 – 8 Ohms
BRIDGED BRIDGED
CH1 CH2 CH3 CH4
SPEAKER OUTPUT
25
I N T E R C O N N E C T I O N E X A M P L E S
Connect the stereo RCA output (FL/FR and
RL/RR) of the headunit with LINE INPUTS
Switch position HP or FULL
CH1/CH2
BASS BOOST LOW PASS
X-OVER
LP/BP FULL
0dB 12dB 30Hz 150Hz HP 10Hz 150Hz
BASS BOOST LOW PASS
X-OVER
LP/BP FULL
10Hz 150Hz
0dB 12dB 30Hz 150Hz HP
CH3/CH4
Switch position
HP or FULL
FL
Loudspeaker
rear / right
2 – 8 Ohms
NSC475
CH1/2 and CH3/4 of the amplifier
LINE INPUT OUTPUT
HIGH PASS INPUT LEVEL CH1 CH3
R
6V 0.2V
HIGH PASS INPUT LEVEL
L
6V 0.2V
CH2 CH4
FR RR RL