Interconnection Example 1-Channel Mode: 1X Mono Subwoofer Bridged - MB QUART Nano NSC 2100 Installation Manual

INTERCONNECTION EXAMPLE 1-Channel Mode: 1x Mono Subwoofer bridged

GND REM 12V
POWER
PROTECT
POWER INPUT
Subwoofer
4 – 8 Ohms
INTERCONNECTION
• Connect the RCA lineout of the headunit with the RCA jack LINE INPUT CH L of the amplifier with an appropriate high-value RCA
cable. If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
• Connect the subwoofer with the speaker outputs (SPEAKER OUTPUT + BRIDGED -) by using appropriate wires.
• Ensure by any means, that the total impedance load of the channel-pair is not lower than 4 ohms. Too low impedance cause high
temperature and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
CROSSOVER SETTINGS
• In the mono/subwoofer mode the X-OVER switch must set to the LP/BP position (Lowpass/Bandpass mode), thereby the higher
frequencies will be eliminated. The cut-off frequency ist adjustable with the LOW PASS controller and should be set between
60 to 100 Hz, depending on the size of the subwoofer.
• In the lowpass mode (LP/BP) the HIGH PASS controller works also as subsonicfilter, that eliminates the ultra-low, not hearable and
harmful frequencies to generate a bandpass signal (Bandpass mode). The subsonic frequency should be set between 15 to 40 Hz,
depending on the size of the subwoofer. NOTE: If this value is higher than the lowpass setting, no sound is hearable.
LEVEL CONTROLLER
• Turn the INPUT LEVEL controller of the amplifier to the 6V position.
• Turn the volume controller of the headunit to 80 - 90% of its full setting.
• Turn the INPUT LEVEL controller clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL controller slightly until you hear a cleaner sound.
BASS BOOST CONTROLLER
• The BASS BOOST controller adjusts the bass enhancement between 0db and +12dB.
• A too high bass boost may cause clipping/distortion and damage on the loudspeakers and also may harm your hearing abilities.
Use this controller carefully!
REFERENCE NOTE
Do not connect loudspeaker cables with the vehicle chassis. Always ensure the correct polarity of all connections.
Use the bass enhancement with care. A high bass boost may cause damage to your speakers and hearing abilities.
BRIDGED
R L
FUSE
SPEAKER OUTPUT
I N T E R C O N N E C T I O N E X A M P L E S
BASS BOOST LOW PASS X-OVER
LP/BP
0dB 12dB 30Hz 250Hz HP
Switch position LP/BP
Connect one mono RCA output (L, R or SUB OUT)
of the headunit with LINE INPUT L of the amplifier
23
NSC2100
Switch position MONO
LINE INPUT OUTPUT
HIGH PASS INPUT LEVEL MODE
L L
FULL
15Hz 250Hz 6V 0.2V STEREO MONO
R R
L